Lift UPS-Automatic Rescue Device 

Microcontroller PFC Based Charger 

Switching Element

MOSFET

Control Type

DSP

Type of Charger 

PFC

Efficiency

95%

Battery Charging Stages 

5(Health Maintain Check for 7AH)

---

Power Factor

0.8

---

Battery

Low Cut Off

10V (Per Battery) +/- 2%

---

Low Cut Off Recovery 

12V (Per Battery) +/- 2%

---

Low Buzzer

10.2V (Per Battery) +/- 2%

High Cut Off

15.5V (Per Battery) +/- 2%

High Cut Off Recovery 

15V (Per Battery) +/- 2%

---

Charging current by Grid

1 +/-2%

---

Output

Output @ No Load

220V+/2%

Output Frequency

50V+/2%

Output @ Full Batt to Low Batt

220V+/-10%

---

Output Low Cut 

150

---

Output High Cut 

260

---

Output Low Retry

1Time

---

Output Short Circuit 

1Time

---

UPS Backup Time

2 Minutes 

---

No Load Battery Current

2%

---

Overload

3.6/KVA

---

Mains

No. of Phase

1Phase-2Wire P,N

---

Voltage range

120V-280V +/-2%

---

Mains Low recovery range 

10V

---

Mains High recovery range 

5V

---

Frequency range 

50Hz +/-3%

---

Battery Charging Stages 

5

---

Inverter

Switching Element

MOSFET

Control 

PWM

Output Voltage  

220V+/2%

Phase

1Phase-2Wire P,N

Output Waveform

Sine Wave

---

Frequency

50Hz

---

Changeover UPS to Mains

<10ms

Changeover Mains to UPS

<10ms

---

Output Power factor 

0.8 Pf

---

Switch 

UPS ON/OFF

Indication

Inverter On, Battery Low / High, Overload, Mains Charging On, Mains On

Alarm

Battery Low, Overload, Charger On, Inverter On 

---

Protection 

overload, Short Circuit Protection, Over Voltage, Mains Surge and Transient Protection (MOV Varistors), Reverse Polarity of Battery, Over temperature Protection, Under voltage and over voltage Protection 

---

Operating Temp 

0-50C

Operating Humidity 

<95

Protection Class

IP20

NOTE: Due to continuous improvement in the product and design. These specification may deviate a bit from the actual product, but only in a better way.